A lot of people seem to have trouble building a house on their own.
Some, however, have found that they can build their own from a few simple blocks of wood.
Here are some tips to help you get started with building your own home in Lego.
First you’ll need to decide which type of wood you want to use.
For this article we’re using walnut.
You’ll need two pieces of wood for the top and bottom of your house, but you can also use walnut for the outside walls, roof and even the ground floor.
Once you’ve decided on which type, you’ll then need to cut the pieces to the desired dimensions.
Start by cutting one side of the walnut piece and glueing it onto the other piece.
Then you’ll make sure that the pieces are flush with each other and don’t rub together.
Next you’ll cut one side and attach it to the other, with a nail or similar piece.
Next, you can attach the outside pieces using glue.
Finally, you’ve got to make sure the inside pieces are lined up properly.
For example, you could make a house with one side facing towards the sun, and the other side facing away from it.
As a rule of thumb, the bigger the piece you use, the larger the size of the house.
To make a nice square, you might want to go for the first size you find.
In fact, it’s not too bad to just use a square of the first width.
And, if you want something smaller, you may want to get rid of the outer pieces.
If you’re happy with your final shape, you’re ready to start building.
Here’s how it goes:1.
Cut a piece of wood of the same width as the pieces you want your house to be, so that the middle of the piece is equal to the width of the bottom piece.2.
Make sure that each of the two pieces has the same thickness.3.
Add a nail to the outside of the pieces.4.
Make two more nails on the inside of the edges of the top piece.5.
Add nails on either side of a corner of the outside piece.6.
Secure the pieces with glue.7.
Attach the two outside pieces to each other with nails.8.
Cut out the walls using a knife or similar.9.
Attaching the roof piece to the bottom of the roof is a bit more tricky, so we’ll cover this in a separate article.10.
Finish the rest of the building by gluing the roof to the inside.
Note that you’ll want to cut a little of the wood into the roof.
The glue can make this a bit difficult to remove.
11.
Attached to the top of the base, you need to add the roofing trim to the base.12.
The bottom of each house should be facing towards you, so cut out the two corners of the inside and top pieces.13.
Once you’ve finished all of the walls and roofs, glue the whole thing together with glue sticks.
14.
Attachment the bottom floor is a little tricky, as you can’t glue the floor to the roof directly, but it’s probably ok. 15.
Once everything is connected, you don’t need to make any more adjustments, as the roof will be attached to the walls.
16.
Attaches the roof, and you’re done.
When you’re finished, it should look something like this: The finished house is almost as big as it looks in Lego You can get a little fancier by adding extra floors, but this is really not needed.
On to the house…
Next, attach the walls to the floor.
I made the roof on the outside, so it’s pretty easy to attach it.
Once it’s all done, you should have something like the picture above.
With a little extra glue, it looks like this.
You’ll also need to glue the interior of the home to the ground.
It’s a bit trickier than you might think, so here’s how I did it.
Step 1: Attach the top floor to a wooden plank.
Step 2: Start attaching the outside floor to another wooden plank, this time to the wall.
The inside of your home should look like this now.
Step 3: Continue to attach the roof and walls to this wooden plank until you’re satisfied with your finished results.
If you need more help, I recommend reading this guide.